You are on PERI's international website. Click here to switch to PERI USA. Click here to view all PERI websites.

PEP Ergo Slab Props

Overview

PEP Ergo Props are mainly used for supporting slab formwork. Numerous practical features ensure fast and safe handling – this includes, for example, the Adjusting Nut indicating the direction or the ergonomic G-Hook which does not jam.
Galvanization guarantees a long service life. However, if a prop does get damaged during the tough everyday working operations on the jobsite, the inner and outer tubes can be replaced separately.

PERI PEP Ergo Props are characterized by a further increase in load-bearing capacity and numerous trend-setting detailed solutions with low dead weight.

The capacity factor – defined as the load-bearing capacity to prop weight ratio – can reach up to 70 % above the values of comparable slab props. PERI PEP Ergo Props fully comply with Load Class B, D, and E of EN 1065. The maximum load-bearing capacity is 50 kN.

The complete galvanization of all surfaces guarantees a long service life.

Load-bearing capacity far beyond the norm
Prop load up to 50 kN – with a comparatively low dead weight
(PEP Ergo E-300+: G = 19.3 kg; max. F = 50.4 kN)

Quickly adjusted
The 12 cm long adjustment range eliminates frequent re-positioning whilst the measuring scale on the inner tube accelerates length pre-adjustments

Simple connections
Prop heads can be attached to both the inner and outer tubes

Trendsetting adjusting nut
The form of the lowering nut dictates the direction of lowering the load while the captive handgrip allows easy adjustment


Technical Details

Product variants

Length Weight Max. load-bearing capacity
PEP Ergo B-300 14.0 kg 30 kN
PEP Ergo B-350 15.6 kg 30 kN
PEP Ergo D-150 9.1 kg 30 kN
PEP Ergo D-250 13.1 kg 35 kN
PEP Ergo D-300+ 15.9 kg 35 kN
PEP Ergo D-350+ 19.2 kg 40 kN
PEP Ergo D-400 23.2 kg 40 kN
PEP Ergo D-500 30.7 kg 40 kN
PEP Ergo E-300+ 19.3 kg 50 kN
PEP Ergo E-350+ 21.7 kg 50 kN
PEP Ergo E-400 26.6 kg 50 kN

 

Further technical details

 

  • Fully galvanized tubular steel slab props for transferring vertical loads
  • Maximum prop load: 50 kN
  • Building authority approved (PEP Ergo) | type-tested (PEP 20, PEP 30)
  • Prop lengths: up to 1.50 m | 2.50 m | 3.00 m | 3.50 m | 4.00 m | 5.00 m
  • Generous adjustment range of 12 cm
  • Total length stamped on inner tube in 10-cm increments to the pegging holes
  • Tripods or frames available as installation aids
  • Anti-crush device with a safety clearance of 10 cm provides protection against injury
  • Prop type and length can be read directly from the outside on the end plate, also on stacks of props

Do you have a project?

Contact us