Plywood with light absorbent coating for matt, low-pore concrete surfaces.
11 alternate veneers of birch and spruce with birch face veneers. Absorbent MDO coating on front side, with 120 g/m² phenolic resin on the rear.
thickness: 21 mm
size: 1250 x 2500 mm
weight: 11,90 kg/m²
The first size named for the panel information is always the grain direction of the face veneer (principal load-bearing direction).
Advantages
Application
The Beto-S is an inexpensive plywood sheet with which concrete surfaces with high technical requirements can be realised. In addition, the sheeting can easily be worked on (sawing, nailing etc.).
Storage
When storing the units on site, attention should be given to the units being uniformly well protected or equally exposed to the weather. It is only possible to obtain a relatively equal result if the plywood of each unit has acclimatized relatively equally.
Release agent
Only formlining which has been well looked after can ensure a uniform good quality concreting finish. Therefore, PERI recommends using PERI Clean and PERI Bio Clean as release agents. The plywood sheets are thus optimally prepared for their next use. If other release agents are used, the user must check whether the required results can actually be achieved.
More information on PERI release agents can be found in the “Accessories” section.
Edge treatment / Edge sealing
As soon as plywood is cut, attention should be given to the cut edges being immediately sealed again.
